TM5-6675-326-14
6-6.2.25 Point Counts With Point Counter Pen and Constants - Continued
j .
k .
l .
m.
n.
o .
When multiplying counts by two to four constants, key in
each constant followed by ~~1.
After last constant has been keyed in, press
f
, and e.
m>
Press CLEAR button to clear auto-scaler.
Using point counter pen, make point count.
Press PRINT to obtain results of count.
Change X MEMORY switch to 2. Press CLEAR button to clear
a u t o - s c a l e r.
Using point counter pen, make point count.
Press PRINT to obtain results of count.
Repeat steps m through q if there is another constant being
used.
p.
q.
r .
6-6.2.26 Standard Volume Run Using Contour Method
a. Assemble QPS with planimeter.
b.
Activate QPS:
(1) Plug foot switch into ACCU input jack on back panel of
a u t o - s c a l e r.
(2) Plug remote tracer switch into PRINT input jack on
back panel of auto-scaler.
(3) Plug planimeter into E2 e n c o d e r s o c k e t o n b a c k p a n el
o f a u t o - s c a l e r.
(4) Plug power transformer cable
back panel of auto-scaler .
(5) Plug power transformer cable
(6) Plug power cord into back of
into POWER supply jack on
i n t o w a l l o u t l e t.
c a l c u l a t o r .
( 7 ) P l u g p o w e r c o r d i n t o w a l l o u t l e t.
(8) Set encoder OFF/E2 / E1 switch on back panel of
auto-scaler to E2 .
6-73
