TM5-6675-326-14
6-6.2.26 Standard Volume Run Using Contour Method - Continued
h .
i .
j .
k .
1.
m.
n .
o.
p .
q .
r .
( 2 ) K e y i n v e r t i c a l s c a l e , p r e s s
-*
(3) Key in RT v a l u e , p r e ss
=*
Key in section interval of contours to be measured, and
p r e s s [-] .
Press
A t o c a l l u p s u b r o u t i n e A .
D e t e r m i n e i f o b j e c t o f c o n t o u r i s c u t ( e x c a v a t i o n ) o r f i l l
(embankment).
(1)
If
contour
is
fill,
press
B .
( 2 ) I f c o n t o u r i s c u t , p r e s s f
and b.
P r e s s INIT button to clear calculator .
Key in value for elevation of first contour to be measured .
Press c .
Place planimeter at starting point of boundary line for
measuring contour loop.
Make practice trace to make sure tracer arm will cover area
in one operation .
Press CLEAR button to clear auto-scaler.
Trace boundary line of contour loop with dot in lens tracing
assembly.
Stop when you reach starting point.
Press and hold down remote tracer switch to activate PRINT
command.
NOTE
l
C a l c u l a t o r w i l l p r i n t t h e f o l l o w i n g i n f o r m a t i on
after the first measurement.
* * * E l e v a t i on
***Section of contour loop
c
Additional measurements will provide values
for intermediate volume and total volume.
0.00 Intermediate volume in cubic yards
0.00 Total volume in cubic yards
6-75
