TM
5-6675-324-14
(c) Plug power transformer cable into POWER supply jack on back panel of
auto-scaler.
(d) Plug power transformer cable into wall outlet.
(e) Plug transformer power cord into back of calculator.
(f) Plug power cord into wall outlet.
(g) Set encoder OFF/E2/E1 switch on back panel of auto-scaler tO E2.
(h) Set AUDIO/OFF switch on back panel of auto-scaler to AUDIO.
(i) Set auto-scaler B/ACCU/A/OFF switch to A.
(j) Set auto-scaler MAN/AUTO switch to MAN.
(k) Set auto-scaler X MEMORY switch to 1.
(1) Set calculator OFF/ON switch to ON.
(m) Set calculator MAN/TRACE/NORM switch to NORM.
(n) Set calculator PRGM/RUN switch to RUN.
(o) Press following keys:
CAUTION
Hold magnetic cards by edge. Be sure hands are clean. Grease, oil, or
other materials may damage magnetic cards.
(3) Load preprogrammed magnetic card (paragraph 5-6.2h), Program II, in
calculator.
(4) Tape map or drawing to be measured to table.
(5) Select correct tracer arm length.
NOTE
The tracer arm length should be shortest one possible that will allow
entire shape to be measured without moving the planimeter.
(6) If needed, aline planimeter with tracer arm length selected (paragraph
(7) Record RT value.
5-71
