TM 5-6675-324-14
(p) Press
following
keys:
CAUTION
Hold magnetic cards by edge. Be sure hands are clean. Grease, oil, or
other materials may damage magnetic cards.
(3) Load preprogrammed magnetic card (paragraph 5-6.2h), Program I, into
calculator.
(4) Tape drawing or map to be measured and paper for layout to table.
(5) If needed, aline linear measuring probe (paragraph 5-6.2 n). Record RL
value.
NOTE
Factory determined RL value is given on Calibration Record Sheets
provided with equipment. Alinement is performed as a check.
(6) Key in scale of map or drawing on which measurements will be made.
NOTE
If layout is to be drawn to a different scale than original map or
drawing, key in scale for layout.
(7) Press
and a.
(8) Press
and d for printout in feet and inches.
(9) Press CLEAR button to clear auto-scaler.
(10) Press foot switch.
Do not release until ready to begin measurement.
(11) Position linear measuring probe so that pricking pin is at beginning of
length to be measured.
(12) Release foot switch.
(13) Make measurement by tracing length of line with linear measuring probe.
(14) Depress, then release foot switch to initiate print command.
(15) Position linear measuring probe on layout sheet at beginning of line just
measured.
(16) Press pricking pin.
5-66
