TM 5-6675-324-14
CAUTION
Grease, oil, or
Hold magnetic cards by edge. Be sure hands are clean.
other materials may damage magnetic cards.
(3) Load preprogrammed card (paragraph 5-6.2h), Program I, into calculator.
(4) Tape drawing or map to be measured to table.
(5) When multiplying counts by one constant, key in constant, press
and
(6) Press CLEAR button to clear auto-scaler.
(7) Using point counter pen, make point count.
(8) Press PRINT to obtain results of count.
(9) To make point count with two to four constants, follow steps (1) through
(4).
(10) When multiplying counts by two to four constants, key in each constant
followed by
(11) After last constant has been keyed in, press
(12) Press CLEAR button to clear auto-scaler.
(13) Using point counter pen, make point count.
(14) Press PRINT to obtain results of count.
(15) Change X MEMORY switch to 2.
(16) Press CLEAR button to clear auto-scaler.
(17) Using point counter pen, make point count.
(18) Press PRINT to obtain results of count.
(19) Repeat steps (13) through (18) if there is another constant being used.
Standard volume run using contour method.
x.
(1) Assemble QPS with planimeter.
(2) Activate QPS.
(a) Plug foot switch into ACCU input jack on back panel of auto-scaler.
(b) Plug linear measuring probe into E1 encoder socket on back panel of
auto-scaler.
5-70
