TM 5-6675-324-14
(j) set auto-scaler B/ACCU/A/OFF switch to A.
(k) Set auto-scaler MAN/AUTO switch to AUTO.
(1) Set auto-scaler X MEMORY switch to 1.
(m) Set calculator OFF/ON switch to ON.
(n) Set calculator MAN/TRACE/NORM switch to NORM.
(o) Set calculator PRGM/RUN switch to RUN.
(p) Press following keys:
CAUTION
Hold magnetic cards by edge. Be sure hands are clean. Grease, oil, or
other materials may damage magnetic cards.
(3) Load preprogrammed magnetic card (paragraph 5-6.2h), Program II, into
calculator.
(4) Tape map or drawing to remeasured to table.
(5) Select correct tracer arm length.
NOTE
The tracer arm length should be shortest one possible that will allow
entire shape to be measured without moving the planimeter.
(6) If needed, aline planimeter with tracer arm selected (paragraph 5-6.21).
(7) Record RT value.
NOTE
provided with equipment. Alinement is performed as a check.
(8) Key in horizontal and vertical scales of contour map or photo and RT
value.
(a) Key in horizontal scale, press
(b) Key in vertical scale, press
(c) Key in RT value,
press
5-74
