TM 5-6675-324-14
NOTE
Factory determined RT value is given on Calibration Record Sheet
provided with equipment. Alinement is performed as a check.
(8)
Key in horizontal and vertical scales of contour map or photo and RT
value.
(a) Key in horizontal scale, press
(b) Key in vertical scale, press
(c) Key in RT value, press
(9)
Key in section interval of contours to be measured, and press
(l0)
Press
to call up subroutine A.
Determine if object of contour is cut (excavation) or fill (embankment).
(11)
(a) If contour is fill, press
(b) If contour is cut, press
and b.
Press INIT button to clear calculator.
(12)
Key in value for elevation of first contour to be measured.
(13)
Press
(14)
Place planimeter at starting point of boundary line for measuring contour
(15)
loop.
(16) Make practice trace to make sure tracer arm will cover area in one
operation.
(17)
Press CLEAR button to clear auto-scaler.
(18) Trace boundary line of contour loop with dot in lens tracing assembly.
Stop when you reach starting point.
(19) Press and hold down remote tracer switch to activate PRINT command.
5-72