TM 5-6675-324-14
(17) Press CLEAR button to clear auto-scaler.
(18) Using a straightedge as a guide, move linear measuring probe until auto-
scaler LED display shows count total identical to previously measured line.
(19) When LED display shows the same count, stop linear measuring probe.
(20) Press pricking pin.
NOTE
Pricking pin marks identify beginning and end of lines being laid out.
(21) For each new line, repeat steps (7) through (20).
(22) To change scale or function, press
to initiate calculator memory.
v.
Linear measuring probe measurements without the calculator.
(1) Assemble the QPS with the linear measuring probe.
(2) Activate the QPS:
(a) Plug foot switch into ACCU input jack on back panel of auto-scaler.
(b) Plug linear measuring probe into El encoder socket on back panel of
auto-scaler.
(c) Plug power transformer cable into POWER supply jack on back panel of
auto-scaler.
(d) Plug power transformer cable into wall outlet.
(e) Plug power cord into back of calculator.
(f) Plug power cord into wall outlet.
(g) Set encoder 0FF/E2/E1 switch on back panel Of auto-scaler tO El.
(h) Set AUDIO/OFF switch on back panel of auto-scaler to AUDIO.
(i) Set auto-scaler B/ACCU/A/OFF switch to A.
MAN.
(j) Set auto-scaler MAN/AUTO switch to
(k) Set auto-scaler X MEMORY switch to 1.
(1) Set calculator OFF/ON switch to OFF.
(m) Set auto-scaler NORMAL/SCALE switch to scale.
(3) Tape map or drawing to be measured to table.
5-67
