TM 5-6675-324-14
NOTE
Calculator will print the following information after the first measurement:
***Elevation
***Section of contour loop
Additional measurements will provide values for intermediate volume and
total volume.
0.00 Intermediate volume in cubic yards
0.00 Total volume in cubic yards
(20) Move to next contour loop.
(21) Release remote tracer switch.
(22) Repeat steps (18) and (19) until desired volume is determined.
(23) To change contour interval when next loop to be measured is at a
different interval, key in new interval. Press
and a.
(24) If last elevation is not even contour interval, key in value for last
and c. Repeat steps (18) through (23).
elevation. Press
(25) To start a new run, press
and b to initiate memory. Repeat
steps (12) through (18).
Merging volume runs.
y.
(1) Assemble QPS with planimeter.
(2) Activate QPS.
(a) Plug foot switch into ACCU input jack on back panel of auto-scaler.
(b) Plug remote tracer switch into PRINT input jack on back panel of
auto-scaler.
(c) plug planimeter into E1 encoder socket on back panel of auto-scaler.
(d) Plug power transformer cable into POWER supply jack on back panel of
auto-scaler.
(e) Plug transformer power cable into wall outlet.
(f) Plug power cord into back of calculator.
(g) Plug power cord into wall outlet.
(h) Set encoder 0FF/E2/E1 switch on back panel of auto-scaler to E1.
(i) Set AUDIO/OFF switch on back panel of auto-sealer to AUDIO.
5-73
