TM 5-3610-253-14
WARNING
Electrical shock hazard. You must stand on rubber matting as a protective
measure before performing this procedure. Death or serious injury may
occur.
d. Turn on power.
(1)
Turn on circuit breaker.
Using operator key, unlock safety lock.
(2)
Turn main power switch to I positi on.
(3)
Turn Star-Delta switch to Y positi on. After main motor has reached
(4)
full speed, turn switch to
position.
Press control power on switch.
(5)
Move backgauge forward or backward as required until backgauge position
e.
is displayed on measurement display.
NOTE
Ream of paper must be even on all sides.
Backgauge must be properly adjusted to be sure that measurements are made
correctly (paragraph 5-36.15).
f. Place ream of paper onto cutting table and position backgauge so that
measurement display reads 25.00 or any whole number. Be sure paper is
fitted tightly against the backgauge.
Using clamp foot pedal, lower clamp onto paper.
g.
Pressing both cutting buttons, cut paper.
h.
i.
After the knife has risen, release the clamp foot pedal.
Remove paper under clamp and measure its width using the pocket caliper.
j.
k. If the measurement is larger than the displayed measurement, add the
difference to the recorded adjustment dial readings obtained in step c.
If the measurement is smaller than the displayed measurement, subtract
l.
the difference from the recorded adjustment dial readings obtained in
step c.
5-635
