TM 5-3610-253-14
(5) While observing multimeter, move receiver until maximum reading is
obtained; then tighten retaining screws.
(6) Repeat steps d. through f. for remaining receivers.
i.
Reinstall light barrier side covers.
Turn off power.
j.
(1) Turn Star-Delta switch to Y position, then to O position.
(2) Turn main power switch to O position.
(3) Using operator key, lock safety lock.
5-40.63 Adjust Power Supplies.
MOS:
35E, Special Electronic Devices Repairer
TOOLS:
Flat Tip Screwdriver
Digital Multimeter
SUPPLIES: Rubber Matting
a.
Turn on power.
(1) Using operator key, unlock safety lock.
(2) Turn main power switch to I position.
(3) Turn Star-Delta switch to Y position. After main motor has reached
full speed, turn switch to
position.
(4) Press control power on switch.
WARNING
Electrical shock hazard. You must stand on rubber matting as a protective
measure before performing this procedure. Death or serious injury may
occur.
b. Remove front electronics enclosure cover.
5-640
