TM 5-3610-253-14
b.
Remove safety bolt cover.
c.
Check the distance between the proximity switches and the safety bolt
with the feeler gage. The distance should be 0.8 mm (.03 in.). If
not, adjust switches as follows:
(1) Loosen switch locking nuts and move switch in or out until 0.8 mm
(.03 in.) clearance is obtained.
(2) Tighten locking nuts.
d. Reinstall safety bolt cover.
e.
Place operator key back into safety lock.
MOS: 35E, Special Electronic Devices Repairer
PERSONNEL: Two persons are required to perform this procedure.
TOOLS :
Flat Tip Screwdriver
No. 0 Cross Tip Screwdriver
a.
Turn on power.
(1)
Turn on circuit breaker.
(2)
Using operator key, unlock safety lock.
Turn main power switch to I position.
(3)
5-637