TM 5-3610-253-14
While performing a cutting operation, check the pressure reading on the
j.
manometer gage. If between 30 (427 psi) and 32 bar (455 psi), proceed
to step m.
k.
If the pressure is above 32 bar (455 psi) or below 30 bar (427 psi), it
will be necessary to adjust the green cable. This is done by loosening
the nuts on the mounting bar for the cable and moving the cable in for
more pressure, and out for less pressure.
l.
Repeat steps j. and k. until proper pressure is obtained.
m.
Set clamp pressure adjustment knob to 3000.
While performing a cutting operation, check the pressure reading on the
n.
manometer gage. If the reading is 115 bar (1636 psi), proceed to step
q.
If the pressure is above or below 115 bar (1636 psi), it will be
o.
necessary to adjust the clamp pressure adjusting knob. This is done by
removing the knob and rotating the scale ring to allow for either more
or less rotation of the knob.
Repeat steps n. and o. until proper pressure is obtained.
p.
5-627
