TM 5-3610-253-14
WARNING
Be sure knife carrier assembly is blocked with 2 x 4's. Serious injury
or death may occur from failure to observe this precaution.
l.
Remove grease fitting, nut, and connecting rod from eccentric.
WARNING
Serious injury may occur if inadequate number of personnel are used to
move main drive gear and clutch assembly. This equipment weighs
approximately 280 lbs (127 kg).
m.
Have three persons hold the main drive gear and clutch assembly from
behind the cutter. A fourth person must remove the mounting bolts and
carefully remove defective main drive gear and clutch assembly.
n.
Drive out pin and pry eccentric from drive shaft.
Reinstall eccentric by alining tab and carefully tap eccentric onto
o.
shaft with hammer.
Have three persons install the new main drive gear and clutch assembly
p.
from behind the cutter while a fourth person installs mounting bolts.
Manually rotate clutch and install connecting rod shear bolt.
q.
r.
Reinstall top cover.
s.
Reinstall eccentric cover plate.
Reinstall both sides of the main motor V-belt cover.
u.
Reconnect the hydraulic pipe.
v.
5-600