TM 5-3510-253-14
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS:
19 mm Open End Wrench
Paper
SUPPLIES:
Turn on circuit breaker.
a.
b. Using operator key, unlock safety lock.
c.
Turn on power.
(1) Turn main power switch to I position.
(2) Turn Star-Delta switch to Y position. After main motor has reached
full speed, turn switch to
position.
(3) Press control power on switch.
d. Move backgauge forward or backward as required until backgauge position
is displayed on measurement display.
e.
Place a stack of paper approximately 29-1/2 in. x 22 in. and 3 in. in
height under the clamp. Position the backgauge so that 1/4 in. will be
f. Turn the paper 180 and again trim 1/4 in. off the stack.
Jog the stack of paper tightly against the backgauge rakes. Perform
g.
another cut this time cutting off two inches of paper.
h. Remove 3/4 in. of paper from the top and bottom of the stack. Place the
top of stack on the bottom and the bottom on the top.
5-458