TM 5-3610-253-14
(2) Remove backgauge rakes by removing bolts, washers and springs holding
rake to backgauge. Clean bottom and front surfaces of rakes.
NOTE
Use care in reinstalling center rake to avoid dropping bolts.
Ensure rakes are flush with table so that one piece of paper cannot slide
under rakes.
(3) Reinstall backgauge rakes using bolts, washers and springs. Tighten
bolts, then loosen bolts 1/2 turn.
b. Perform light barrier adjustments (paragraph 5-40.62).
Clean knife and knife carrier and perform knife adjustments (paragraph
d. Clean false clamp and clamp as follows.
(1) Pull out clamp pressure adjustment knob.
(2) Lower clamp to 2 in. above table.
5-386
