TM 5-3610-253-14
(8)
Secure table to frame using all screws.
Remove hoist from table.
(9)
(10) Connect all electrical connectors to the proper connections in the
electronics enclosure.
(11) Install the left and right light barrier housings to front frame, ensuring
that the housings are square to the table and frame.
(12) Connect light barrier plug connectors.
(13) Install the right and left side tables; secure in place with bolts.
(14) Install the table sides to the backgauge table.
(15) Secure the backgauge table to the mounting frame.
(16) Install main motor V-belts (paragraph 5-36.4).
(17) Remove rust protection film and dirt from around and on the sledge.
(18) Install the backgauge onto the sledge. Make sure that all concave
washers are fitted between the concave spacer and backgauge. This will give the
proper distance 3 mm (.12 in.) between the backgauge and the table.
(19) Install cutting stick (paragraph 5-30.1 steps e. through g.).
(20) Install paper cutter into van (paragraph 5-40.50).
a.
Clean the paper cutter as follows.
(1) Using grease remover, clean all grease from the bed assembly surfaces
including sides and front table.
NOTE
Use care in removing center rake to avoid dropping bolts.
5-385
