TM 5-3610-253-14
k. Remove main power switch knob and reinstall
onto control panel.
l.
Reinstall main drive gear clutch cover.
m. Reinstall eccentric cover.
Contact your battalion for packing and
5-17. PREPARATION FOR STORAGE OR SHIPMENT.
shipping instructions.
Section V
DIRECT/GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
5-18. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT.
5-18.1 Common Tools and Equipment. For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
5-18.2 Special Tools: Test, Measurement, and Diagnostic Equipment; and Support
Equipment. Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
5-18.3 Repair Parts. Repair parts are listed and illustrated in the repair parts
and special tools list, TM 5-3610-253-24P covering direct/general support
maintenance for this equipment.
DIRECT/GENERAL SUPPORT TROUBLESHOOTING PROCEDURES.
a. Direct/general support troubleshooting procedures cover the most common
malfunctions that may be repaired at the direct/general support level. Repair or
adjustment requiring specialized equipment is not authorized unless such equipment
is available. Troubleshooting procedures used by lower level maintenance should be
conducted in addition to the direct/general support troubleshooting procedures.
b. For unidentified malfunctions, use the following schematics and/or the
foldouts located at the end of this manual for further fault analysis.
c. Prior to using the troubleshooting procedures for electrical malfunctions,
always check plug connections and fuses.
d. Prior to using the troubleshooting procedures for hydraulic malfunctions,
always check for loose or leaky pipe connections or possible air in the hydraulic
system.
