TM 5-3610-253-14
(3) Remove false clamp by pulling out on false clamp release pins and
locking them off.
(4) Clean the false clamp and clamp.
(5) Reinstall false clamp in storage location under the table.
(6) Rotate the knife changing 1 ever back to normal position and raise the
clamp.
Check that knife is square with backgauge by performing backgauge angle
adjustment procedure (paragraph 5-16.25).
f. Adjust OCL by loosening locking nuts and moving mounting rod in and out, and
around, until cutting line is bright and sharp.
Oil backgauge in accordance with paragraph 5-11, lubrication instructions.
g.
h. Check adjustment of false clamp switch (S6) by moving the backgauge fully
forward. Be sure the backgauge rakes come far enough up to intertwine with the
rakes of the clamp. Perform following steps if adjustment is required:
(1) Remove front electronics enclosure cover.
5-95
