TM 5-3610-253-14
b. This crate can be used to ship the defective paper cutter and should not be
destroyed.
5-13.1
Check ink Unpacked Equipment.
Inspect all parts of the equipment for damage incurred during shipment. If
the equipment has been damaged, report the damage on DD Form 6, Packing Improvement
Report.
f the shipment is
b. Check the equipment against the packing list to see
instructions of DA Pam
complete. Report all discrepancies in accordance with the
738-750.
c.
Check to see whether the equipment has been modified
5-13.2 Deprocessing Unpacked Equipment.
a. The following sequence of steps are used to complete the assembly of the paper
cutter.
(1) Remove the rear electronics enclosure cover.
(2) Install the clamp foot pedal (paragraph 5-16. 10).
(3) Remove all rust protection film and dirt from table surfaces.
5-91
