TM 5-3610-253-14
Table 5-7. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES - Cont
AN - Annually
(Number) - Hundreds of Hours
B - Before
W - Weekly
s - Semiannually
D - During
M - Monthly
BI - Biannually
A - After
Q - Quarterly
ITEM TO BE INSPECTED
lN-
ITEM
TER-
NO.
PROCEDURE
VAL
PAPER CUTTER - Cont
Inspect Main Motor V-Belts - Cont
M
2
3. Check V-belts for wear, cracking or oil
deposits. Replace if defective.
4. Check V-belts deflection. Deflection
should be 10 mm (3/8 in.). If deflection
differs from specifications, adjust V-belts by:
(a) Loosen locknuts on underside of motor
adjusting mount.
(b) Turn adjusting bolts to the right to
tighten V-belts, or to the left to loosen
V-belts. Be sure to turn both bolts the
same amount each time to keep pulley alinement.
(c) Tighten locknuts on underside of motor
adjusting mount.
5. Reinstall main motor V-belt cover.
Organizational troubleshooting procedures cover the most common malfunctions
that may be repaired at the organizational level. Repair or adjustment requiring
specialized equipment is not authorized unless such equipment is available.
Troubleshooting procedures used by the operator should be conducted in addition to
the organizational troubleshooting procedures.
b. This manual cannot list all the possible malfunctions or every possible test/
inspection and corrective action. If a malfunction is not listed or is not
corrected by a listed corrective action, notify your supervisor.
For unidentified malfunctions, use the facing schematic and/or the foldout
located at the end of this manual for further fault analysis.
5-100
