TM 5-3610-253-14
NOTE
Use care in removing center rake to avoid dropping bolts.
(2) Remove backgauge rakes by removing bolts, washers, and springs holding
rake to backgauge. Clean bottom and front surfaces of rakes.
NOTE
q Use care in reinstalling center rake to avoid dropping bolts.
q Ensure rakes are flush with table so that one piece of paper can not
slide under rakes.
Tighten
(3) Reinstall backgauge rakes using bolts, washers and springs.
bolts, then loosen bolts 1/2 turn.
Perform light barrier focusing (paragraph 5-16.19, steps a-c, and i).
b.
c. Clean knife and knife carrier and perform knife adjustments (paragraph
5-16.13).
d. Clean false clamp and clamp as follows.
(1) Lower clamp to 2 in. above table.
(2) Rotate knife change lever to knife changing position.
5-94
