TM 5-3610-253-14
Pull defective power cord free from box.
9.
h. Thread new power cord through 45 degree conduit into box.
i.
Strip white and black wire ends approximately 3/8 in. (9.5 mm), and
replace wire nuts (black wire to black wires; white wire to white
wires).
Crimp eyelet on power cord around wire; reconnect power cord ground wire
j.
and motor ground wire with ground screw in back of box.
k. Pull slack from wires in box and tighten screws on conduit clamp.
1.
Reinstall cover plate and secure with screws.
m.
Plug in power cord.
MOS: 83FJ6, Reproduction Equipment Repairer
1/2 in. Combination Wrench
TOOLS:
3/32 in. Hex Head Key Wrench
Crimping Tool
Flat Tip Screwdriver
Ball Peen Hammer
Punch Set
Hand Wire Stripper
SUPPLIES: Motor, Electric (1/4 HP)
Eyelets
Wire Nuts
Silicone Spray (Item 27, Appendix E)
WARNING
Death or serious injury may occur from electrical shock unless power cord
is unplugged before servicing.
Unplug power cord.
a.
b. Loosen thumbscrews and move auto-trip backgage out of the way.
c.
Remove drift hole cover.
d. Remove drill bit using drill drift.
e.
Remove thumbscrews and pressure foot.
f. Remove power cord tiedowns.
2-31
