TM 5-3610-253-14
c. For unidentified malfunctions, use the following schematic or foldout located
at the end of this manual for further
d. If the paper drilling machine does not power-up
when turned on, verify that
120 V ac is present at the receptacle. If voltage is
not present, plug equipment
into receptacle with power available and proceed with
equipment troubleshooting.
Perform no-power procedures for dead receptacle (Table
Table 2-3. ORGANIZATIONAL TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
DRILL HEAD WILL NOT RETURN TO UP POSITION.
Manually lift head up by pulling up on motor and inspect for broken lift
spring(s).
Replace broken lift spring(s) (paragraph 2-16.1).
2-26
