TM 5-3610-253-14
o.
Remove spindle from defective motor by pulling straight off the motor
shaft.
Lubricate drive shaft on new motor with small amount of silicone spray.
P.
Reinstall and aline spindle on new motor drive shaft and secure with
q.
hex head screws.
Install new motor and spindle in spindle housing and secure motor to
r.
mounting bracket.
NOTE
Shims may have to be placed behind motor mounting bracket to be sure motor
is at a 90 degree angle to the cutting block and that the spindle does not
bind on the spindle housing.
s.
Thread new motor power cord through 90 degree conduit clamp.
t.
Strip white and black wire ends about 3/8 in. (9.5 mm) and replace with
wire nuts.
Crimp eyelet on new motor power cord ground wire if necessary.
u.
Connect power cord ground wire and motor ground wire with ground screw.
v.
Pull slack from wires in box and tighten screws on conduit clamp.
w.
Reinstall cover plate and secure with screws.
x.
Reinstall motor power cord tiedowns.
Reinstall pressure foot and secure with thumbscrews.
y.
Reinstall drift hole cover.
z.
Reinstall drill bit.
aa.
ab.
Position and secure auto-trip backgage with thumbscrews.
ac.
Plug in power cord.
.
2-33
