ARMY TM 9-6675-349-12&P
MARINE CORPS TM 11039-12&P
T-Handle
Bolt
Alignment Pins
Alignment Pin
Bracket
Assembly
T-Handle Bolt
(Hand-tighten Only)
Load-distributing
Washer
(1) Locate alignment pin bracket assembly, figure 2-7, and place it over the two threaded inserts on the left
side of floor plate with alignment pins facing the right passenger side of the vehicle.
(2) Place one load distributing washer between alignment bracket assembly and T-handle bolt.
(3) Hand tighten alignment pin bracket to floor plate with two T-handle bolts, figure 2-7, and two washers.
CAUTION
ENSURE THAT ALL T-HANDLE BOLTS ARE ONLY HAND TIGHTENED.
(4) Place IPADS frame on floor plate. Ensure the Porro Prism Assembly (PPA) and cover face towards the
rear of the vehicle.
