ARMY TM 9-6675-349-12&P
MARINE CORPS TM 11039-12&P
2-8. Install IPADS in High-Mobility Multi-Purpose Wheeled Vehicle (HMMWV) Continued
(2) First Wire (Black).
In the HMMWV locate the CURRENT SHUNT, figure 2-13 (1).
(a) Follow the wire from the CURRENT SHUNT to the connecting battery terminal (5), figure 2-13.
Connect the black lead of W116-1 to this terminal.
(b) If the battery plastic boots are installed in the vehicle, use the pocket knife to cut a hole into the
side of the plastic boot covering the terminal, figure 2-14. This facilitates insertion of the battery
cable for providing DC power to the IPADS.
(c) Route the end of each cable branch through two l-inch holes in transmission tunnel, under vehicle
body, and through 1 l/2-inch hole in battery box. This hole is located just below current shunt
mounted on the inside wall of vehicle battery compartment
(d) To connect the black lead to the battery terminal (5), use a 9/16" wrench to install the black wire,
to the side of the terminal marked IPADS cable (3), figure 2-13.
(3) Second Wire (Red).
In the HMMWV locate the BATTERY INTERCONNECT CABLE, figure 2-13 (2).
CAUTION
The BATTERY INTERCONNECT CABLE and the terminals at both ends are
to be left alone. They will not be connected to the IPADS equipment, as
damage will occur.
(a) Connect the red wire (5) of the IPADS cable to the remaining HMMWV battery terminal (3),
(b) If the battery plastic boots are installed in the vehicle, use the pocketknife to cut a hole into the
side of the plastic boot covering the terminal, Figure 2-14. This facilitates insertion of the battery
cable for providing DC power to the IPADS.
(c) To connect the Red wire to the battery terminal, (5) use a 9/16" wrench to install the red wire, to
the side of the terminal marked IPADS Cable (3), figure 2-13.
(4) Replace commander's seat; latch in place.
(5) Attach W116-1 connector P1 to IPADS BCU DC input connector, figure 2-16.
2-18
