ARMY TM 9-6675-349-12&P
MARINE CORPS TM 11039-12&P
(6) If vehicle is equipped with a communication mount for the SINCGARS radio and an external speaker,
the lower shelf that holds the speaker will need to be temporarily modified in order to remove the front
two cross tip screws under the speaker stand. Proceed as follows:
(a) Using a 7/16-inch socket and a 7/16-inch box end wrench, remove the two bolts that support the
front of the speaker shelf.
(b) Elevate the speaker shelf to gain access to the front two cross tip screws that secure the wooden
noise abatement board. Using a 3-inch cross tip screw driver, remove the two cross tip screws and
finish the removal of the noise abatement board.
(c) When the noise abatement board has been removed, install the speaker shelf back to its original
form using the two 7/16-inch bolts.
(7) If the vehicle has a PADS installation kit installed, remove it.
b. Remove Cargo Tiedown Ring:
NOTE
The M998 has threaded inserts under the cargo floor to secure the cargo
tiedown ringbolts. The cargo tiedown ringbolts are secured by nuts and
lockwashers under the cargo floor of the M1097 and M1123. Removal of
M1097 and M1123 cargo tiedown rings requires a -inch wrench for the
nuts in addition to the 3/4-inch combination wrench needed for the bolts.
An individual vehicle may or may not have cargo tiedown rings installed at
the three IPADS floor plate attachment points, figure 2-5. Remove any
cargo tiedown rings from those locations as follows.
2-9
