ARMY TM 9-6675-349-12&P
MARINE CORPS TM 11039-12&P
2-8. Install IPADS in High-Mobility Multi-Purpose Wheeled Vehicle (HMMWV) Continued
(1) Place floor plate over three existing holes, figure 2-5, in vehicle cargo bed, two forward and one to the
rear. Ensure "THIS SIDE UP" is visible.
(2) Using 9/16-inch wrench, install and tighten four 3/8-16 UNC-2B by 1-inch long screws and flat
washers to secure CDU support arm to floor plate.
(3) For M998, install three l/2-13UNC-2A by 3-inch long bolts, with flat and lock washers, through floor
plate holes into threaded inserts under vehicle cargo bed, figure 2-6. Finger-tighten only.
NOTE
If any of the threaded inserts under the vehicle cargo bed are missing install the
floor plate using flange nuts.
(4) For M1097 and M1123, install three l/2-13UNC-2A by 3-inch long screws, flat washers, and lock
washers through floor plate holes into holes in vehicle cargo bed.
(5) With CDU support arm in place, apply a small amount of forward force (towards radio) to ensure all
three floor plate holes and 1/2-inch bolts are aligned.
(6) Using 3/4-inch wrench, tighten the three l/2-inch screws securing floor plate to vehicle cargo bed.
d. Install IPADS:
WARNING
IPADS weighs approximately 135 lbs (61.4 kg); use at least four persons to lift
and move it.
CAUTION
DO NOT lift the IPADS unit using the porro prism cover.
2-12