TM 5-6675-318-14
(6) If the tape stops immediately at a site record, press the clear (C) key
and re-enter code 40 (Table 4-12).
When load is displayed, press enter (E) key. If
RSET YES is displayed, change to RSET NO by pressing the change sign (+/-) key, then
press the enter (E) key.
Tape will continue to be read into memory.
(7) If END is displayed, 17 acceptable passes were not available on this
tape. If more data is available, load new tape as follows:
(a) Position the tape to the beginning of tape (BOT) by entering code
41 (Table 4-12).
(b) Load contents into memory by entering code 40. If RSET YES is
displayed, change to RSET NO by pressing change sign (+/-) key, and then enter (E)
key.
Tape will load until FULL is displayed.
( 8)
Display and
( 9)
(10)
(11)
step a, (2)
(12)
Code 77).
(12.1)
(13)
When FULL is displayed, press clear (C) key, then enter code 99.
record the last pass number in memory, then press clear (C) key.
Rewind the tape by entering code 49 and remove the cassette.
Install the second tape.
Extract the 3D position of the last pass recorded in accordance with
and (3) above.
Enter the 3D position of the second tape by entering code 77 (Table 4-10,
Rewind tape using code 41.
Start translocation process by entering code 46 (Table 4-13). When TRAN
is displayed, press the enter (E) key.
If RSET NO-is displayed, change-to read
RSET YES by pressing change sign (+/-) key then enter (E) key.
Table 4-13. CODE 46 DISPLAYS FOR TRANSLOCATING FROM TAPE
This code is operative only in the off-line mode. Enter code 46 to read satellite
data from tape and compute a translocated position. The tape will stop after
reading a site record. Code 46 must be re-entered to continue.
When code 46 is entered, the unit asks the user how many satellite passes to
process.
I n i t i a l D i s p l a y
4-90 Change 3