TM 5-6675-318-14
Table 4-11.
CODE 47 DISPLAYS FOR 3D POSITION FROM TAPE - Cont
When computing a point position, the unit also stores in its memory the data needed
for subsequent translocation processing with another site. he last 17 acceptable
passes are held in memory. Code 99 may be used to display the field processed data.
Done Processing
( a ) I f t h e t a p e s t o p s i m m e d i a t e l y a t a s i t e r e c o r d , d i s p l a y w i ll
indicate site and number.
Press clear (C) key and re-enter code 47.
(b) When PNTP is displayed, press enter (E) key. If RSET YES appears,
press change sign (+/-) key to display RSET NO, then press enter (E) key.
NOTE
It will take two to three minutes to process each pass.
(c) When END is displayed, press the clear (C) key.
(d) Rewind the tape by entering code 49 and remove cassette.
( e ) I f t h e r e i s m o r e d a t a t o b e p r o c e s s e d , c o n t i n u e a t s t e p ( f ) . I f n o
more data is to be processed, proceed to step (h).
( f )
( g)
( h)
Install new tape and position to BOT using code 41.
Enter code 47 and repeat steps (b) through (e) above.
Display the survey site 3D position location in satellite datum
using code 63 (Table 4-6, page 4-65). Record the display 3D position on DA Form
1959.
(i) Convert the 3D position to both local and UTM datum in accordance
with paragraph 4-6.3.4, page 4-98.
(7) If all data has been processed, perform your after PMCS, Table 4-1.
Change 2
4-87
