TM 5-6675-318-14
b.
T r a n s l o c a t i o n w i t h 1 - s i t e t a p e s .
The following procedures enable the
determination of a remote site location, using two separate tape sets: one recorded
at a control site (known position) and one recorded at a remote site (estimated
p o s i t i o n ) .
With data collected on tape from a sufficient number of acceptable
satellite passes (Table 4-4), the translocated position of the remote site will be
accurate to within 1 meter (3.28 ft) rms.
Translocated position is computed in the
s a t e l l i t e d a t u m , e l i m i n a t i n g e r r o r s d u e t o l o c a l d a t u m d i s t o r t i o n.
This technique
r e q u i r e s s y s t e m i n i t i a l i z a t i o n i n t h e s a t e l l i t e d a t u m . T h e s i m p l e s t w a y t o i n-
i t i a l i z e a p o s i t i o n i n t h e s a t e l l i t e d a t u m i s t o u s e t h e 3 D p o s i t i o n s o l u t i on
already recorded on cassette tape during data collection.
The functional diagram
shows translocation with 1-site tapes.
Assemble and prepare the equipment for use
(paragraphs 4-6.1 and 4-6.2), and proceed as follows:
FUNCTIONAL DIAGRAM, TRANSLOCATION WITH 1-SITE TAPES
(1) Select the off-line mode of operation by entering code 10.
NOTE
The first tape (usually from the remote site) is the one whose first pass
recorded occurred at a later time than first pass recorded on the second
tape.
(1.1) To check which tape has the later recorded pass, perform the following:
tape.
t i o n .
(a) Install one tape and rewind it using a code 41.
(b) Enter code 44, followed by a +1 to read the first pass on the
(c) After the tape stops, enter code 99 to display the pass inform-
( d ) R e c o r d t h e t i m e a n d d a y o f t h e f i r s t p a s s .
(e) Enter code 41 to rewind the tape, then remove tape.
(2) Install the first tape.
( 3 ) E x t r a c t t h e p o i n t p o s i t i o n o f t h e l a s t p a s s r e c o r d e d i n a c c o r d a n c e w i th
(f) Repeat the above steps for the second tape.
step a, (2) and (3) above, page 4-80.
4-88 Change 2