TM 5-6675-318-14
Table 4-14. CODE 44 DISPLAY FOR READ PASS - Cont
To move to a desired pass that is identified by a pass number on the tape, enter a 0
digit, space, then the pass number.
After selecting the tape movement, press the enter (E) key and the tape will move as
specified. Pressing (E) with no entry moves the tape forward to the next pass on
tape. Code 99 may be used to display data read by code 44.
Move Forward To Pass 22
( b ) I f m o r e d a t a i s t o b e p r o c e s s e d , r e i n s t a l l t h e f i r s t t a p e a n d e n t er
code 44 (Table 4-14).
(c) Key in 0, space, , and the pass number recorded in step (8),
above, page 4-90.
(d) Repeat steps (6) through (10), above, page 4-90.
(e) Reinstall the second tape and enter code 44.
(f) Key in 0, space , and the pass number recorded in step (16),
above.
(g) Continue the translocation process by entering code 46 (Table 4-
1 3 ).
When TRAN is displayed, press the enter (E) key. IF RSET YES is displayed,
change to read RSET NO by pressing the change sign (+/-) key, then the enter (E)
k e y .
(h) Repeat steps (14) and (15) above.
(i) Repeat steps (a) through (h) above until all desired data has been
processed.
(j) Rewind tape by entering code 49, remove the cassette, and proceed
to step (18).
(17) If END was displayed in step (15), more tape data is required. Rewind
the tape by entering code 49, remove the cassette, and proceed as follows:
(a) Install a new control site tape and position the tape to the
beginning of tape (BOT) by entering code 40 (Table 4-12).
4-94 Change 3
