TM 5-6675-316-14
CAUTION
Use care when handling and mounting paper tape or damage to tape could
result,
(6) Carefully lay tape on reader between guides so that sprockets of drive wheel engage leader (HERE IS)
holes in beginning of tape.
(7)
(8)
(9)
(l0)
(11)
(12)
(13)
Push plastic lid in place over tape, so that locking tab engages.
Push tape punch ON key.
Push tape reader lever to STOP and then to START.
Observe tape printout on teletype.
NOTE
Unless tape is being changed or corrected, let entire tape run before stopping
reader.
To stop tape reader at any time, push reader lever to STOP.
When entire tape has been read, stop tape reader.
Remove old tape from reader and copy from tape punch.
(14) To make sure copy was punched correctly, run copy through tape reader and compare its printout to
printout of original.
NOTE
If tape is only being read and printed, not copied, tape punch should be OFF.
q. Running tape on machine controller. Basic procedure involves placing tape in machine controller tape
reader and using operator’s console to control reader.
(1)
(2)
(3)
(4)
Check that correct drawing, map, and tools are mounted on drafting machine.
Set machine for automatic operation (paragraph 3-6.3a).
Turn on machine controller.
Perform operator’s test of automatic system (paragraph 3-6.2).
3-110
Change 1
