TM 5-6675-316-14
Table 3-7. DRAFTING TAPE COMMANDS - Cont
Command Code
Meaning
Notes on Use
G91
Point Input CodesCent
Designates incremental input.
Zero point changes after each input. Followed by
pen codes and/or X-and Y-point coordinates.
Used alone.
Example: G91
M00
Program stop command.
Typed on line alone.
n. Punching tape on teletype.
(1) Assemble system and set for automatic operation (paragraph 3-6.3a).
(2) Turn teletype power switch to LOCAL.
(3) If needed, install paper tape and/or paper roll in teletype (paragraph 3-6.3g or 3-6.3 h).
(4) Remove any old programs on paper roll or tape.
(5) Press tape punch ON key.
3-106
Change 1