TM 5-6675-316-14
s. Manually inputting drafting commands with operator’s console. Basic procedure involves using console
command of VARIA function.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
3-7) one line at a time.
Turn on machine controller.
Set machine for automatic operation (paragraph 3-6.3a).
Press RESET on operator’s console.
Press VARIA.
Type scale factor and preset coordinates into operator’s console (table 3-8, items SCA and PRE).
Deleted.
Press VARIA and then type CON and press CR.
NOTE
Display should show asterisk (*) in right-hand corner.
Type in drafting program command lines exactly as they are typed and punched on drafting tapes (table
(9) End each command by pressing CR.
t. Moving machine to point with operator’s console.
(1)
(2)
(3)
(4)
(5)
(6)
Set machine for automatic operation (paragraph 3-6.3a).
Turn on machine controller.
Press RESET on operator’s console.
Press VARIA.
Type scale factor and preset coordinates into operator’s console (table 3-8, items SCA and PRE).
Type CON and press CR.
NOTE
Display should show asterisk (*) in its right-hand corner.
3-114
Change 1
