TM 5-6675-316-14
NOTE
If change or correction being input is only addition of commands in middle of
tape and none of codes already on tape will be changed, it is not necessary to
manually type in rest of program. Simply turn tape reader on after addition is
typed in and duplicate rest of program.
(5) If any codes (commands) on old tape were changed or eliminated, manually type remainder of program
on teletype keyboard.
(6) When tape is complete, run it on tape reader and check printout for errors.
(7) Discard old tape.
p. Duplicating and/or printing tape program with teletype. Basic procedure involves placing tape to be
duplicated in tape reader of teletype, blank tape in tape punch, and then turning on both units. Everything read
on tape by reader will be printed out (in alphanumerics) by teletype. When tape punch is on, anything typed by
teletype is also punched on tape.
(1) Assemble and set machine for manual operation (paragraph 3-6.3 a).
(2) Turn teletype power switch to LOCAL.
(3) Remove any old tapes or programs from teletype and tape punch.
(4) Press spring tab on tape reader to one side so that plastic lid springs up.
(5) Push tape reader lever to FREE.
Change 1
3-109
