TM 5-6675-316-14
(11) Remove punched tape and printout from teletype. Check printout to make sure program was input
correctly. If there are any errors, tape must be corrected.
o. Correcting or changing tape program with teletype.
(1) Set tape to be changed in tape reader as if it is to be duplicated (paragraph 3-6.3a).
(2) While watching printout, turn tape reader to START, and duplicate tape up to point where program is to
be changed or corrected. When this point is reached, push reader lever to STOP.
(3) If tape reader and punch copies too many blocks, proceed as follows:
(a) Backspace tape punch with B.SP. key.
(b) Press RUB key to nullify unwanted codes.
(4) Type in change or correction to tape with teletype keyboard.
3-106
Change 1
