TM 5-3610-287-24
DIRECT SUPPORT AND
GENERAL SUPPORT MAINTENANCE
Section I. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND
DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
3-1. COMMON TOOLS AND EQUIPMENT. For authorized common tools and
equipment, refer to the Modified Table of Organization and Equipment (MTOE)
applicable to your unit.
3-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. For repair of the
Section at direct support and general support maintenance, refer to the
repair parts and special tools list (RPSTL), TM 5-3610-287-24P, and the
Maintenance Allocation Chart (MAC), appendix B of this manual.
3-3. REPAIR PARTS. Repair parts are listed and illustrated in the repair
parts and special tools list (RPSTL), TM 5-3610-287-24P, covering direct
support and general support maintenance for this equipment.
Section II.
SERVICE UPON RECEIPT
3-4. SITE REQUIREMENTS.
The Section should be located on firm, level
ground.
3-5. SERVICE UPON RECEIPT OF MATERIEL. Refer to table 2-1 of this manual
for those inspections to be made upon receipt of the Section.
3-6.
CHECKING UNPACKED EQUIPMENT
a. Inspect the Section for damage incurred during shipment. If the
equipment has been damaged , report the damage on SF Form 364, Report of
Discrepancy (ROD).
b. Check the equipment against the packing slip to see if the shipment
is complete. Report all discrepancies in accordance with the instructions
of DA PAM 738-750.
c. Check to see whether the equipment has been modified.
3-7. PRELIMINARY SERVICE. Check lubrication of Section components as
outlined in the lubrication order LO 5-3610-287-12.
