TM 5-3610-287-24
2-67.
REPAIR WINCH ASSEMBLY (CONT)
Remove nuts (1) and cable clamps (2).
1.
Cut shrink tubing (3) and remove.
2.
Remove keeper hook (4) and wire rope thimble (5).
3.
Thread cable (6) through new shrink tubing (3).
4.
WARNING
Cable clamps must be installed exactly as illustrated. Clamp
saddle must be on end of cable coming off reel. If saddle is
installed on return end of cable, cable may slip and cause
serious injury.
5.
Install new wire rope thimble (5), new keeper hook (4), cable clamps
(2), and nuts (1).
6.
Slide shrink tubing (3) over loose end of cable (6) until cable end is
1/2-inch from shrink tubing end.
7.
Shrink the shrink tubing (3) by applying hot air directly to tubing.
WARNING
Stay clear as folding floors are raised or lowered. Weight
of floors may cause serious injury.
8.
Test operate by raising and lowering folding floor.
REPAIR HANDWINCH
a. Handle b. Worm gear assembly
Handwinch is repaired by replacing:
c. Ring gear and reel
HANDLE
INITIAL SETUP
Tools
Light machine repair tool kit (appendix B, section III, item 11)
Socket wrench set
Materials/Parts
Handle, 0854-11
2-211
