TM 5-3610-287-24
ORGANIZATIONAL MAINTENANCE
Section I. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND
DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
2-1. COMMON TOOLS AND EQUIPMENT. For authorized common tools and
equipment, refer to the Modified Table of Organization and Equipment (MTOE)
applicable to your unit.
2-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. For repair of the
Section at organizational maintenance, refer to the repair parts and
special tools list (RPSTL), TM 5-3610-287-24P, and to the Maintenance
Allocation Chart (MAC), appendix B of this manual.
2-3. REPAIR PARTS. Repair parts are listed and illustrated in the repair
parts and special tools list (RPSTL), TM 5-3610-287-24P, covering
organizational maintenance for this equipment.
Section II.
SERVICE UPON RECEIPT
2-4. SITE REQUIREMENTS. The Section should be located on firm, level
ground. Allow ample space for expanding the sides to prevent contact
with power lines and other obstructions.
2-5. SERVICE UPON RECEIPT OF MATERIEL. The following inspections listed
in table 2-1 should be made upon receipt of the Section.
Service Upon Receipt of Materiel
REMARKS
ACTION
ITEM
LOCATION
1.
Exterior
Shell and Exterior
a.
Inspect all four
Components
sides, top, and
bottom for dents,
punctures, loose
parts, missing
components, and for
corrosion.
b.
Reject Section if
damage will prevent
proper operation.
