TM 5-3610-287-24
Section III. DIRECT SUPPORT AND GENERAL
SUPPORT PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
3-8. GENERAL . There is no PMCS at the direct support and general support
levels. Refer to table 2-2 for organizational level PMCS.
Section IV.
DIRECT SUPPORT AND GENERAL SUPPORT TROUBLESHOOTING
3-9. GENERAL. This section contains the checks and corrective actions for
the direct support/general support technician to troubleshoot the Section
and its components. The table lists common malfunctions you may find
during operation or maintenance of the Section. The tests/inspections and
corrective actions should be performed in the order listed.
This manual cannot list all malfunctions, tests/inspections, or
corrective actions. If a malfunction is not listed or is not corrected by
the listed corrective actions, notify your supervisor.
Direct Support and General Support Troubleshooting
Table 3-1.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
BINDING FELT WHEN SIDE IS EXPANDED OR DOES NOT OPEN OR CLOSE EVENLY.
Count teeth on upper and lower gear racks on both ends of expanding
side.
If teeth count of upper and lower gear racks on one end
If teeth count on one end does not equal teeth count on
If binding still occurs, adjust roller bearing and upper
Section V. DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE PROCEDURES
3-10. GENERAL . This section contains direct support and general support
maintenance procedures as authorized by the Maintenance Allocation Chart
(MAC), appendix B of this manual. The following topics are included as
applicable: a. Installation b. Removal c. Repair. All maintenance
procedures in this section will be performed by one Photolithographer
are required for a procedure, the MOS is shown in the initial setup.