TM 5-3610-286-10
2-7.
h.
plate
OPERATING PROCEDURE (CONT)
Remove Plate (Cont)
(6) Put printing Press on safe.
Release lead edge clamp (3) with
wrench.
(7) Remove plate and packing from lead edge clamp (3).
(8) Install plate cylinder guard.
WARNING
EXPOSED MOVING PARTS.
Do not inch Printing Press and
wipe cylinder at the same time.
Return Printing Press
to SAFETY STOP after each inching.
Failure to do so
may result in serious injury.
(9) Take Printing Press off safe.
Wipe down plate cylinder (4) and
bearers (5) with clean rag and lithographic solvent.
(10) Apply light coat of oil to plate cylinder and bearers to prevent
rust.
Put Printing Press on safe.
i.
Drain Dampening Assembly
INITIAL SETUP
Materials/Parts
Plastic tubing (appendix B, section III, item 37)
Rag (appendix D, item 50)
Water
General Safety Instructions
WARNING
l
EXPOSED MOVING PARTS.
All adjustments will be made while
Printing Press is on SAFETY STOP except those authorized by
this manual to be made with Printing Press running.
Printing
Press must be on safe at all times when not in motion. Always
shout “clear” and wait for "clear” response before taking
Printing Press off safe to inch or run.
Failure to follow
this warning may result in serious injury.
l
EXPOSED MOVING PARTS.
Remove all jewelry. Keep shirts
tucked in, sleeves above elbows, and ties removed.
Failure
to observe these precautions while operating Printing Press
may result in serious injury.
2-103
