TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
h.
Remove Plate
INITIAL SETUP
Tools
Plate wrench (appendix B, section III, item 43)
17 mm open-end wrench (appendix B, section III, item 40)
Materials
Lithographic solvent (appendix D, item 56)
Rag (appendix D, item 50)
Oil (appendix D, item 38)
General Safety Instructions
WARNING
l EXPOSED MOVING PARTS.
All adjustments will be made while
Printing Press is on SAFETY STOP except those authorized by
this manual to be made with Printing Press running.
Printing
Press must be on safe at all times when not in motion.
Always shout “clear” and wait for “clear" response before
taking Printing Press off safe to inch or run.
Failure to
follow this warning may result in serious injury.
l EXPOSED MOVING PARTS.
Do not inch Printing Press and wipe
cylinder at the same time.
Return Printing Press to SAFETY
STOP after each inching.
Failure to do so may result in
serious injury.
l EXPOSED MOVING PARTS.
Remove all jewelry. Keep shirts
tucked in, sleeves above elbows, and ties removed.
Failure
to observe these precautions while operating Printing Press
may result in serious injury.
2-101
