TM 5-3610-286-10
2-7.
OPERATING PROCEDURE (CONT)
h.
Remove Plate (Cont)
(1) Remove plate cylinder guard.
(2) Loosen tail edge clamp tension nuts (1).
(3) Release tail edge clamp (2) with plate wrench.
(4) Remove plate from tail edge clamp (2).
WARNING
EXPOSED MOVING PARTS.
All adjustments will be made
while Printing Press is on SAFETY STOP except those
authorized by this manual to be made with Printing
Press running.
Printing Press must be on safe at all
times when not in motion.
Always shout clear and
wait for *clear response before taking Printing
Press off safe to inch or run. Failure to follow
this warning may result in serious injury.
(5) Take Printing Press off safe.
Hold plate and packing with right
hand.
Inch Printing Press backward until lead edge clamp (3) is
accessible.
2-102