TM 5-3610-286-10
2-8.
OPERATION OF AUXILIARY EQUIPMENT (CONT)
b.
Nonstop Feeder (Cont)
side
with
stop
(3) Place nonstop feeder bar (1) into notch on side rail (4) on drive
and slide down.
Attach nonstop feeder bar to chain (2) and secure
knurled nut (5).
(4) Slide rods (6) into grooves on feeder board until rods contact
plate.
Space bars for even support of paper.
(5) Press AUXILIARY PILEUP pushbutton until nonstop feeder bar (1)
meets rods (6).
(6) Switch AUXILIARY PILE/MAIN PILE selector switch to AUXILIARY
PILE .
(7) Press MAIN PILE DOWN pushbutton to lower main feeder pile board
until feeder rail (7) can be removed.
(8) Remove wooden spacers, feeder rail, and feeder pile board.
(9) Press MAIN PILE DOWN pushbutton to lower feeder pile board
supports to auxiliary feeder pile board.
Place supports under feeder pile
board.
(10) Install feeder rail (7) to feeder pile board support. Ensure
feeder rail edges are inserted into side rails (4). Insert wooden spacers.
(11) Press MAIN PILE UP pushbutton until pile on feeder pile board
rests against rods (6).
(12) Switch AUXILIARY PILE/MAIN PILE selector switch to MAIN PILE.
(13) Slide rods (6) out from pile.
c. Continuous Delivery
NOTE
l
This procedure is performed with the Printing Press
running.
l
Use of continuous delivery will depend on quantity
of the job being run.
2-107
