TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
g.
Perform Washup Procedures (Cont)
(6) Lower delivery safety gate (3).
Place washup basin (4) over end
shafts (5) and raise delivery safety gate (3).
(7) Take Printing Press off safe and run. Engage feeder and push
PRESET SPEED pushbutton to washup speed.
(8) Squirt a coat of lithographic
no. 18.
solvent across ductor roller
(9) Adjust knurled adjustment screws (6) until edge of washup basin
(4) contacts oscillator roller no. 5 and ink begins to flow into washup
basin.
(10)
roller no.
(11)
(12)
screws (6)
no. 5.
(13)
Apply lithographic solvent to ductor roller no. 18 and rider
13 until all rollers are clean.
Disengage feeder.
With Printing Press at idle speed, turn knurled adjustment
until edge of washup basin (4) moves away from oscillator roller
Put Printing Press on safe.
Lower delivery safety gate (3).
Loosen knurled adjustment screws (6) and remove washup basin (4). Raise
delivery safety gate.
(14) Clean washup basin (4).
WARNING
EXPOSED MOVING PARTS.
Do not inch Printing Press and
wipe cylinder at the same time.
Return Printing
Press to SAFETY STOP after each inching. Failure to
do so may result in serious injury.
(15) Clean blanket with rag and lithographic solvent.
2-100
