TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
f.
Perform Make-Ready Procedures (Cont)
(d) Adjust side guide (para 2-7b (4) (c) and (d)).
(e) Take Printing Press off safe. Run five more test sheets. Put
Printing Press on safe.
(f) Repeat steps (a) through (e) above until desired registration
is obtained.
(g) Scribe register marks on plate.
(8) Begin production and refine adjustments as necessary.
NOTE
For instructions on operation of nonstop feeder and
continuous delivery, refer to paragraph 2-9.
g.
Perform Washup Procedure
INITIAL SETUP
Tools
Putty knife (appendix B, section III, item 22)
Scraping knife (appendix B, section III, item 23)
Materials
Rag (appendix D, item 50)
Lithographic solvent (appendix D, item 56)
General Safety Instructions
WARNING
l EXPOSED MOVING PARTS.
All adjustments will be made while
Printing Press is on SAFETY STOP except those authorized by
this manual to be made with Printing Press running.
Printing
Press must be on safe at all times when not in motion.
Always shout “clear” and wait for “clear” response before
taking Printing Press off safe to inch or run.
Failure to
follow this warning may result in serious injury.
2-98
