TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
f.
Perform Make-Ready Procedures (Cont)
(b) If twist is required to bring the drive side image down, use
following procedure:
1 Loosen two tension bolts (1) on drive side of tail clamp (2).
NOTE
Be sure lateral adjustment screw (3) on drive side
allows sufficient clearance to move tail clamp (2) to
desired position with operator side lateral
adjustment screw (4).
2 Loosen locknut (5) and turn lateral adjustment screw (4) on
operator side up until tail clamp has moved desired distance.
Secure
locknut (5).
3 Turn tension bolt (6) on drive side of lead clamp (7) desired
distance.
4 Turn center tension bolt (8) on lead clamp to right until
finger tight.
5 Tighten two tension bolts (1) on drive side of tail clamp (2).
2-96
