TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
f.
Perform Make-Ready Procedures
INITIAL SETUP
Tools
19 mm T-handle socket wrench (appendix B, section III, item 44)
Plate wrench (appendix B, section 111, item 43)
Straight pin wrench (appendix B, section III, item 42)
13 and 17 mm combination wrench (appendix B, section III, item 39)
Materials
Erasing shield, (appendix D, item 52)
Rags (appendix D, item 50)
Sponge (appendix D, item 57)
Eraser (appendix D, item 15)
Etching needle (appendix B, section III, item 26)
No. 6 pencil (appendix D, item 49)
Bucket (appendix B, section III, item 5)
General Safety Instructions
WARNING
l EXPOSED MOVING PARTS.
All adjustments will be made while
Printing Press is on SAFETY STOP except those authorized by
this manual to be made with Printing Press running.
Printing
Press must be on safe at all times when not in motion.
Always shout “clear” and wait for “clear” response before
taking Printing Press off safe to inch or run.
Failure to
follow this warning may result in serious injury.
l EXPOSED MOVING PARTS.
Remove all jewelry. Keep shirts
tucked in, sleeves above elbows, and ties removed.
Failure
to observe these precautions while operating Printing Press
may result in serious injury.
l ELECTRICAL SHOCK.
Static electricity is retained in static
eliminator bar for up to 2 hours after power is turned off.
Touching static eliminator bar while charged may result in
injury from electrical shock.
l EXPOSED MOVING PARTS.
Do not inch Printing Press and wipe
cylinder at the same time.
Return Printing Press to SAFETY
STOP after each inching.
Failure to do so may result in
serious injury.
2-93
